Engineering knowledge

Resources

Practical notes on casting design, materials, production routes and quality planning.

Filtered library

Case Studies

Case StudyOct 12, 2026

An anonymized CF8M marine deck-drain case covering grate-hole formation, elbow soundness, hose fit and project-specific water and salt-spray checks.

Case StudyOct 12, 2026

An anonymized QT500-7 pump-pipe clamp case covering green-sand casting, hinge soundness, fit control and project-specific assembly testing.

Case StudyOct 12, 2026

A CF8 stainless centrifugal-pump volute case covering cavity formation, shrinkage control, pressure testing and the move into repeat supply.

Case StudyAug 25, 2026

An anonymized 304 stainless manifold case covering DFM review, investment casting, interface inspection and customer installation validation.

Case StudyAug 25, 2026

An anonymized A356 housing case covering leakage investigation, a revised material and process route, renewed sampling and repeat production.

Case StudyAug 25, 2026

An anonymized ADC12 valve-bracket case covering a dimensional nonconformance, a dedicated check gauge and verification of the affected feature.

Case StudyAug 25, 2026

An anonymized A380 solar-mounting case covering tooling, sample approval, controlled edge finishing, dimensional inspection and repeat production.

Case StudyAug 10, 2026

An anonymized A380 die-casting case covering an industrial mounting component, sample finish correction, dimensional checks and repeat production.

Share the alloy, annual volume and critical requirements. Tianlu will review the likely casting and finishing route.