Product application / Agriculture & Construction

Agricultural & Construction Equipment Brackets

Mounting brackets for working equipment need a clear connection between the load case, blank geometry and finished pin or bolt interfaces. Review the bracket with its mating parts and operating environment.

Speak to an Engineer

Application reference: shaft supports within a chain-drive assembly.

Manufacturing routes

Applicable manufacturing processes

Forging

Investment Casting

Sand Casting

Published project evidence

Related manufacturing cases

Explore published components connected to this application.

6 connected cases

T-Shaped Bracket with Threaded Boss showing the component interfaces

Aluminum AlloysADC12Die Casting

ADC12 Die-Cast T-Bracket with Threaded Boss

Application T-Shaped Bracket with Threaded Boss

A broad top plate is supported by a pair of webs leading to a cylindrical connection boss.

View Case Study

Support bracket with a locating post, hooked arm and recessed central web.

Carbon & Low-Alloy SteelsZG270-500Sand Casting

ZG270-500 Sand-Cast Support Bracket with Post and Hook

Application Support Bracket with Post and Hook

A locating post supports a transverse arm with a hooked end and an intermediate seating step.

View Case Study

Saddle Clamp Seat Pair showing the component interfaces

Carbon & Low-Alloy SteelsZG270-500Sand Casting

ZG270-500 Sand-Cast Saddle Clamp Seats

Application Saddle Clamp Seat Pair

Curved matching seats are shown as an upper and lower component set, with elongated mounting openings.

View Case Study

Forged Connector Block with Angled Bore showing the component interfaces

Carbon & Low-Alloy SteelsForging

Forged Steel Connector Block with Angled Bore

Application Forged Connector Block with Angled Bore

A compact thick-section connector combines a large angled bore with a transverse opening and flat contact faces.

View Case Study

Three-Lug Cast Bracket showing the component interfaces

Carbon & Low-Alloy SteelsZG270-500Sand Casting

ZG270-500 Sand-Cast Three-Lug Bracket

Application Three-Lug Cast Bracket

An angled supporting web connects three projecting lugs. The lug openings provide the visible connection features.

View Case Study

Forked Base Bracket showing the component interfaces

Cast IronQT450-10Sand Casting

QT450-10 Sand-Cast Forked Base Bracket

Application Forked Base Bracket

Twin upright arms rise from a broad base with transverse pin features. The open center accommodates the mating moving component.

View Case Study

Manufacturing review

Key manufacturing requirements

Confirm these points on the drawing and purchase specification.

Working connectionIdentify fixed, pivoting or clamped connections, with mounting direction and operating loads defined on the drawing.
Pin bores and lugsSpecify bore fits, lug spacing, alignment and bushing interfaces from the assembled position.
Section transitionsReview ribs, lugs and mounting plates together with deliberate machining stock and clamping access.
Material and routeAgree the material and primary casting or forging route, then plan machining of bores and mounting faces.
Wear and inspectionDefine wear surfaces, coating exclusions and fit checks; agree any proof-load or fatigue test separately.

Materials